Anilox rolls and sleeves: new, reconditioning and rebuilding

Anilox rolls and sleeves for flexo printing

Aufer Solutions supplies new anilox rolls and sleeves, and offers reconditioning and rebuilding of used anilox rolls. Each anilox is specified according to the press, the ink or coating, the line screen, the volume and the cell geometry the job requires.

New anilox rolls and sleeves

  • To fit your press: anilox rolls and sleeves made to the press dimensions and specifications.
  • Line screen, volume and cell geometry: chosen according to the ink, varnish or adhesive and the coverage you need.
  • Working surface: laser-engraved ceramic coating, with different cell geometries depending on the application.
Anilox roll and sleeve for flexo printing

How to choose line screen and volume

The line screen (number of cells per centimetre or per inch) and the cell volume (cm³/m²) determine how much ink the anilox transfers and with what detail.

  • High line screen and low volume: fine screens and detail.
  • Low line screen and high volume: solids, opaque whites, varnishes and adhesives.

The choice also depends on the ink, the substrate and the plate; we advise you with the details of your job.

Reconditioning and rebuilding

When the body of the roll or sleeve can be recovered, the nominal diameter is restored, a new working coating with corrosion protection is applied and the surface is laser-engraved again. Each case is assessed beforehand to check that it is technically and economically viable.

Anilox maintenance

To preserve the cell volume, the anilox should be cleaned regularly. See our high-pressure and ultrasonic anilox washers and our cleaning fluids. A doctor blade in good condition and properly set also protects the surface.

Ask for advice

Tell us the press, the dimensions of the roll or sleeve and the type of job. Request information.

Frequently asked questions about anilox rolls and sleeves

What is the difference between an anilox roll and a sleeve?

An anilox roll is a complete roll; a sleeve is an interchangeable shell mounted on a shaft or mandrel. It is lighter and makes job changes easier.

It depends on the ink, the coverage and the level of detail in the design. High line screens are used for fine screens and detail, low ones when more ink, varnish or adhesive must be laid down.

Clean them regularly with suitable products, avoid knocks on the ceramic surface and work with a doctor blade in good condition and properly set.

The dimensions of the roll or sleeve (or the drawing), the press, the current line screen and volume if you know them, and the type of job: ink, varnish or adhesive, and substrate.